Juniper ACX2000

master
Syntax master {
announce-interval announce-interval-value;
interface interface-name {
unicast-mode {
clock-client ip-address local-ip-address local-ip-address {
manual;
}
}
transport ipv4;
}
multicast-mode {
transport 802.3 ( link-local ) ;
asymmetry number;
}
max-announce-interval max-announce-interval;
max-delay-response-interval max-delay-response-interval;
max-sync-interval max-sync-interval;
min-announce-interval min-announce-interval;
min-delay-response-interval min-delay-response-interval;
min-sync-interval min-sync-interval;
sync-interval sync-interval;
}
Hierarchy Level [edit protocols ptp]
Release Information Statement introduced in Junos OS Release 12.3 for ACX Series Routers.
multicast-mode and transport ieee-802.3 (link-local) options introduced in Junos OS
Release 12.3X51 for the ACX Series Universal Access Routers.
Description Configure the parameters of the master clock port.
The remaining statements are explained separately. See CLI Explorer.
Required Privilege
Level
routing—To view this statement in the configuration.
routing-control—To add this statement to the configuration.
Related
Documentation
• IEEE 1588v2 PTP Boundary Clock Overview on page 234
• Configuring Precision Time Protocol Clocking on page 243
• Configuring a PTP Master Boundary Clock on page 244
• Example: Configuring a PTP Boundary Clock With Unicast Negotiation on page 250
• Example: Configuring a PTP Boundary Clock on page 248
1599Copyright © 2017, Juniper Networks, Inc.
Chapter 41: Configuration Statements