Juniper ACX2000

vci
Syntax vci vpi-identifier.vci-identifier;
Hierarchy Level [edit interfaces at-fpc/pic/port unit logical-unit-number],
[edit interfaces at-fpc/pic/port unit logical-unit-number family family address address
multipoint-destination address],
[edit logical-systems logical-system-name interfaces at-fpc/pic/port unit logical-unit-number],
[edit logical-systems logical-system-name interfaces at-fpc/pic/port unit logical-unit-number
family family address address multipoint-destination address]
Release Information Statement introduced before Junos OS Release 7.4.
Statement introduced in Junos OS Release 11.1 for the QFX Series.
Statement introduced in Junos OS Release 12.2 for the ACX Series Universal Access
routers.
Description For ATM point-to-point logical interfaces only, configure the virtual circuit identifier (VCI)
and virtual path identifier (VPI).
To configure a VPI for a point-to-multipoint interface, specify the VPI in the
multipoint-destination statement.
VCIs 0 through 31 are reserved for specific ATM values designated by the ATM Forum.
Options vci-identifier—ATM virtual circuit identifier. Unless you configure the interface to use
promiscuous mode, this value cannot exceed the highest-numbered VC configured
for the interface with the maximum-vcs option of the vpi statement.
Range: 0 through 4089 or 0 through 65,535 with promiscuous mode, with VCIs
0 through 31 reserved.
vpi-identifier—ATM virtual path identifier.
Range: 0 through 255
Default: 0
Required Privilege
Level
interface—To view this statement in the configuration.
interface-control—To add this statement to the configuration.
Related
Documentation
• Configuring a Point-to-Point ATM1 or ATM2 IQ Connection
• Applying Scheduler Maps to Logical ATM Interfaces
• multipoint-destination
• promiscuous-mode on page 1682
• vpi (ATM CCC Cell-Relay Promiscuous Mode) on page 1776
1773Copyright © 2017, Juniper Networks, Inc.
Chapter 41: Configuration Statements