show ptp global-information
Syntax show ptp global-information
Release Information Command introduced in Junos OS Release 12.2.
Command introduced in Junos OS Release 12.3X54–D20 for ACX500 Series routers.
Description Show Precision Time Protocol (PTP)-related global information.
Options This command has no options.
Required Privilege
Level
view
Related
Documentation
IEEE 1588v2 PTP Boundary Clock Overview on page 234•
• IEEE 1588v2 Precision Timing Protocol (PTP) on ACX Series Universal Access Routers
on page 237
List of Sample Output show ptp global-information on page 2941
Output Fields Table 209 on page 2939 lists the output fields for the show ptp global-information command.
Output fields are listed in the approximate order in which they appear.
Table 209: show ptp global-information Output Fields
Field DescriptionField Name
Configured PTP, master, and slave parameters.PTP Global Configuration
Profile TypeProfile Type
PTP domain with values from 0 through 127. The default value is 0. Only one PTP domain is supported
at any given point in time.
Domain Number
Name of the encapsulation type: Ipv4.Transport Encapsulation
Clock mode is either boundary or ordinary.Clock mode
Priority value of the clock: 0 through 255. The default is 128. The lower value takes precedence.Priority Level1
Priority value of the clock: 0 through 255. The default is 128. This value is used to differentiate and
prioritize the master clocks when the priority1-value is the same for different master clocks in a network.
The lower value takes precedence.
Priority Level2
Method by which the announce, synchronization, and delay-response packet rates are negotiated
between the master and the slave or client before a PTP session is established. Unicast negotiation
is enabled or disabled.
Unicast Negotiation
2939Copyright © 2017, Juniper Networks, Inc.
Chapter 42: Operational Commands
To Next Page
Loading...
Need help?
General
