Table 78: CCC Family Firewall Filter Match Conditions for ACX Series Routers
DescriptionField
Destination MAC addressdestination-mac-address
Matches TCP/UDP destination portdestination-port
Matches differentiated services (DiffServ) code pointdscp
Matches ICMP message codeicmp-code
Matches ICMP message typeicmp-type
Matches destination IP addressip-destination-address
Matches IP precedence valueip-precedence
Matches IP protocol typeip-protocol
Matches source IP addressip-source-address
Matches learned 802.1p VLAN prioritylearn-vlan-1p-priority
Source MAC addresssource-mac-address
Matches TCP/UDP source portsource-port
Matches user 802.1p VLAN priorityuser-vlan-1p-priority
Related
Documentation
show firewall•
• clear firewall
• interface-specific (Firewall Filters)
Standard Firewall Filter Match Conditions for Bridge Family Firewall Filters on ACX
Series Routers
Standard Firewall Filter Match Conditions for Bridge Family Firewall Filters on ACX Series
Routers
Bridge family firewall filters can be configured at the IFL-family level on ACX series routers.
Bridge family filters are used to match the L2 bridge flows based on the supported
Layer2/Layer3 fields and take firewall action. The maximum number of terms supported
for bridge firewall filters on ACX Series routers is 124.
Table 79 on page 1069 shows the match conditions supported for bridge family filters.
Copyright © 2017, Juniper Networks, Inc.1068
ACX Series Universal Access Router Configuration Guide
To Next Page
Loading...
Need help?
General
