Table 107: Parameter for test-name configuration (continued)
DescriptionParameters
Specify the name of the test-profile to be used for the test.
The test-profile parameter is ignored when mode reflect is used.
NOTE: This parameter is not supported on ACX5048 and ACX5096 routers.
test-profile
CFI bit used in the VLAN tag.
NOTE: This parameter is not supported on ACX5048 and ACX5096 routers.
vlan-cfi
Configure the VLAN ID for the test frames.
This parameter is valid only for mode ethernet-loopback.
NOTE: This parameter is not supported on ACX5048 and ACX5096 routers.
vlan-id
Configure the VLAN priority value.
Range: 0 through 7.
NOTE: This parameter is not supported on ACX5048 and ACX5096 routers.
vlan-priority
The following topics describe how to configure a test-profile and a test-name, start and
stop a RFC2544-benchmark test, and copy the test result to a local or a remote file.
•
Configuring a Test Profile for an RFC 2544-Based Benchmarking Test on page 1346
•
Configuring a Test Name for an RFC 2544-Based Benchmarking Test on page 1348
•
Starting and Stopping the RFC 2544-Based Benchmarking Test on page 1354
•
Copying an RFC 2544-Based Benchmarking Test Result on page 1354
Configuring a Test Profile for an RFC 2544-Based Benchmarking Test
You can configure a test profile by including the test-profile profile-name statement at
the [edit services rpm rfc2544-benchmarking] hierarchy level. Table 106 on page 1341 lists
the parameters for configuring test-profile.
To configure a test profile:
1. In configuration mode, go to the [edit services] hierarchy level.
[edit]
user@host# edit services
2. Configure an RPM service instance.
[edit services]
user@host# edit rpm
3. Configure an RFC 2544-based benchmarking test for the RPM instance.
Copyright © 2017, Juniper Networks, Inc.1346
ACX Series Universal Access Router Configuration Guide
To Next Page
Loading...
Need help?
General
