Juniper ACX2000 Configuration Guide

Table 107: Parameter for test-name configuration (continued)
DescriptionParameters
This parameter is valid only in family inet mode. ARP iteration is a 3-second iteration that is run
for all inet tests. The results of ARP iteration are ignored in test result calculations. The primary
use of sending test frames for 3 seconds is to ensure that all devices on the path to destination
build their ARP entries.
NOTE: This parameter is not supported on ACX5048 and ACX5096 routers.
skip-arp-iteration
Specify the source IPv4 address used for the test frames. If a value is not specified for this
parameter, then:
•
For family ccc, if a value is not specified, then by default 192.168.1.10 is used.
•
For family inet, the source address of the interface is used to send out test frames.
NOTE: This parameter is not supported on ACX5048 and ACX5096 routers.
source-ipv4-address
Specify the source MAC address. For example, 0011.2233.4455
This parameter cannot be used when family inet is specified.
This parameter is optional when family ccc is specified. If not specified, then the default value of
0x00:0x60:0x67:0x71:0xC6:0x62 is used.
source-mac-address
Specify the source UDP port number for the test frames.
Default: 4040
NOTE: This parameter is not supported on ACX5048 and ACX5096 routers.
source-udp-port
Number of seconds to wait after transmitting the last frame and before concluding that the test
as complete.
NOTE: This parameter is not supported on ACX5048 and ACX5096 routers.
test-finish-wait-duration
Specify the duration of each iteration in seconds.
Range: 10 through 120 seconds
The default value for test types throughput, back-to-back frames and frame loss rate is 20 seconds.
The default value for test type latency is 120 seconds.
NOTE: This parameter is not supported on ACX5048 and ACX5096 routers.
test-iterator-duration
Specify the name of the logical interface (UNI) on which the test needs to be run.
When you specify the family as inet and mode as initiate-and-terminate the test-interface is ignored,
instead the test is run on egress logical interface that is determined by the route lookup on the
specified destination-ipv4-address.
When you specify the family as inet and mode as reflect, the test-interface is used as the interface
to enable reflection service. If test-interface is not specified, a lookup is performed on the
source-ipv4-address parameter to determine the interface hosting the address.
This parameter is mandatory for mode ethernet-loopback
test-interface
1345Copyright © 2017, Juniper Networks, Inc.
Chapter 37: Configuring RFC 2544-Based Benchmarking Tests

Juniper ACX2000 Specifications

General

Brand	Juniper
Model	ACX2000
Category	Network Router
Language	English