Juniper ACX2000 Configuration Guide

Table 209: show ptp global-information Output Fields (continued)
Field DescriptionField Name
Denotes whether the conversion from clock class to QL is enabled or disabled.ESMC QL From Clock Class
Denotes the user defined clock class to QL conversion.Clock Class/ESMC QLl
Denotes the SNMP trap generation status (Enabled or Disabled).SNMP Trap Status
Parameters configured on the slave clock:
• Sync Interval—Log mean interval between synchronization messages requested during unicast
negotiation.
• Delay Request Interval—Log mean interval between delay-response messages requested during
unicast negotiation.
• Announce Interval—Log mean interval between announce messages requested during unicast
negotiation.
• Announce Timeout—Number of announce messages missed and detected by the slave, resulting
in the slave identifying the master as unreachable.
• Grant Duration—Length of time a unicast grant is assigned for unicast negotiation.
Slave Parameters
Parameters configured on the master clock:
• Sync Interval—Log mean interval between synchronization messages sent to a configured manual
slave.
• Announce Interval—Log mean interval between announce messages sent to a configured manual
slave.
• The minimum and maximum parameters below are the minimum and maximum values accepted
during unicast negotiation from remote clients:
• Min Announce Interval—Log
2
value, which means that announce messages are sent once every
eight seconds. The value should be in the range 0 to 3.
• Max Announce Interval—Maximum acceptable interval between announce messages. The value
should be in the range 0 to 3.
• Min Sync Interval—Minimum acceptable interval between synchronization messages.
• Max Sync Interval—Log
2
value, which means that the maximum synchronization rate is 128
messages per second.
• Min Delay Response Interval—Minimum acceptable interval between delay-response messages.
• Max Delay Response Interval—Maximum acceptable interval between delay-response messages.
• Clock Step—Synchronous timing message: one-step or two-step. With two-step, a subsequent
follow-up message is received after the first synchronous message.
• Holdover In Specification Time—Display the status of holdover-in-specification time. The default
time for holdover-in-specification state is 86400 seconds (24 hours).
Master Parameters
Number of slaves configured on the router.Number of Slaves
Number of masters configured on the router.Number of Masters
Total number of interfaces that are configured to be stateful or dynamic. A stateful port functions as
both a master port and a slave port.
Stateful Ports
Display whether transparent clock is configured.Transparent-clock-config
Copyright © 2017, Juniper Networks, Inc.2940
ACX Series Universal Access Router Configuration Guide

Juniper ACX2000 Specifications

General

Brand	Juniper
Model	ACX2000
Category	Network Router
Language	English