Related
Documentation
Configuring an RFC 2544-Based Benchmarking Test•
• RFC2544-Based Benchmarking Tests Overview
• rfc2544-benchmarking on page 1698
List of Sample Output show services rpm rfc2544-benchmarking summary on page 3158
show services rpm rfc2544-benchmarking aborted-tests (ACX Series
Router) on page 3158
show services rpm rfc2544-benchmarking completed-tests (ACX Series
Router) on page 3159
showservicesrpm rfc2544-benchmarking active-tests (ACX Series Router) on page 3159
show services rpm rfc2544-benchmarking aborted-tests(MX104 Router) on page 3159
showservices rpm rfc2544-benchmarkingcompleted-tests(MX104Router) on page3160
show services rpm rfc2544-benchmarking active-tests (MX104 Router) on page 3160
Output Fields Table 231 on page 3157 lists the output fields for the show services rpm
rfc2544-benchmarking command. Output fields are listed in the approximate order in
which they appear.
Table 231: show services rpm rfc2544-benchmarking Output Fields
Field DescriptionField Name
Details of the performed RFC 2544 benchmarking test.Test information
Unique identifier configured for the test.Test id
Name configured for the test.Test name
The type of statistical detail that is collected for the test, based on the configured
test type. Throughput-related, latency, frame-loss, or back-to-back
frames-related information is displayed for ACX Series routers. Reflected
packets-related information is displayed for MX104 Series routers.
Test type
Mode configured for the test on the router. Test modes are:
• Initiate-and-Terminate: Test frames are initiated from one end and terminated
at the same end. This mode requires a reflector to be configured at the peer
end to enable the test frames to be returned to the source. This mode is
supported only on ACX Series routers.
• Reflect: Test frames that originate from one end are reflected at the other
end on the selected service, such as IPv4 or Ethernet.
Test mode
Size of the test packets in bytes. This field is valid only when the test mode is
Initiate-and-Terminate.
Test packet size
State of the test that is in progress or active when the output is displayed.Test state
Indicates whether the test is currently in progress or has been terminated. This
field is displayed for tests that are in progress or were aborted by entering the
testservices rpm rfc2544-benchmarking test<test-name | test-id>stop command.
Status
3157Copyright © 2017, Juniper Networks, Inc.
Chapter 42: Operational Commands
To Next Page
Loading...
Need help?
General
