To Next Page

To Previous Page

Table 166: show lacp interfaces Output Fields (continued)

Field DescriptionField Name

LACP state information for each aggregated interface:

• Role—Role played by the interface. It can be one of the following:

• Actor—Local device participating in LACP negotiation.

• Partner—Remote device participating in LACP negotiation.

• Exp—Expired state. Yes indicates the actor or partner is in an expired state. No indicates the actor

or partner is not in an expired state.

• Def—Default. Yes indicates that the actor’s receive machine is using the default operational partner

information, administratively configured for the partner. No indicates the operational partner

information in use has been received in an LACP PDU.

• Dist—Distribution of outgoing frames. No indicates distribution of outgoing frames on the link is

currently disabled and is not expected to be enabled. Otherwise, the value is Yes.

• Col—Collection of incoming frames. Yes indicates collection of incoming frames on the link is

currently enabled and is not expected to be disabled. Otherwise, the value is No.

• Syn—Synchronization. If the value is Yes, the link is considered synchronized. It has been allocated

to the correct link aggregation group, the group has been associated with a compatible aggregator,

and the identity of the link aggregation group is consistent with the system ID and operational key

information transmitted. If the value is No, the link is not synchronized. It is currently not in the right

aggregation.

• Aggr—Ability of aggregation port to aggregate (Yes) or to operate only as an individual link (No).

• Timeout—LACP timeout preference. Periodic transmissions of LACP PDUs occur at either a slow

or fast transmission rate, depending upon the expressed LACP timeout preference (Long Timeout

or Short Timeout).

• Activity—Actor or partner’s port activity. Passive indicates the port’s preference for not transmitting

LAC PDUs unless its partner’s control value is Active. Active indicates the port’s preference to

participate in the protocol regardless of the partner’s control value.

LACP State

ACX Series Universal Access Router Configuration Guide

Juniper ACX2000 Configuration Guide

Other manuals for Juniper ACX2000