Juniper ACX2000

Table 60: Standard MIBs supported by Junos OS (continued)
PlatformsExceptionsStandard MIB
ACX Series, EX Series, M Series, MX
Series, PTX Series, SRX Series, and T
Series
No exceptionsRFC 2580, Conformance Statements for
SMIv2
M Series, MX Series, SRX Series, and T
Series
No exceptionsRFC 2662, Definitions of Managed Objects
for ADSL Lines
ACX Series, EX Series, M Series, MX
Series, PTX Series, SRX Series, and T
Series
For M Series, T Series, and MX Series, the
SNMP counters do not count the
Ethernet header and frame check
sequence (FCS). Therefore, the Ethernet
header bytes and the FCS bytes are not
included in the following four tables:
•
ifInOctets
•
ifOutOctets
•
ifHCInOctets
•
ifHCOutOctets
However, the EX switches adhere to RFC
2665.
RFC 2665, Definitions of Managed
Objects for the Ethernet-like Interface
Types
NOTE: The list of managed objects
specified in RFC 2665 has been updated
by RFC 3635 by including information
useful for the management of 10-Gigabit
per second Ethernet interfaces.
ACX Series, EX Series, M Series, MX
Series, PTX Series, SRX Series, and T
Series
Unsupported table and objects:
•
vrrpStatsPacketLengthErrors
NOTE: Junos OS does not support this
standard for row creation and the Set
operation.
RFC 2787, Definitions of Managed Objects
for the Virtual Router Redundancy
Protocol
ACX Series, EX Series, M Series, MX
Series, PTX Series, SRX Series, and T
Series
Supported tables and objects:
•
hrStorageTable
NOTE: The file systems /, /config, /var,
and /tmp always return the same
index number. When SNMP restarts,
the index numbers for the remaining
file systems might change.
•
hrSystem group
•
hrSWInstalled group
•
hrProcessorTable
RFC 2790, Host Resources MIB
973Copyright © 2017, Juniper Networks, Inc.
Chapter 29: Understanding Network Management