Juniper ACX2000

Table 81: Firewall Filter Match Conditions for VPLS Traffic (continued)
Description
Match Condition
(MX Series only) Match IPv6 payload protocol type.
The following list shows the supported values for protocol:
•
ah—IP Security authentication header
•
dstopts—IPv6 destination options
•
egp—Exterior gateway protocol
•
esp—IPSec Encapsulating Security Payload
•
fragment—IPv6 fragment header
•
gre—Generic routing encapsulation
•
hop-by-hop—IPv6 hop by hop options
•
icmp—Internet Control Message Protocol
•
icmp6—Internet Control Message Protocol Version 6
•
igmp—Internet Group Management Protocol
•
ipip—IP in IP
•
ipv6—IPv6 in IP
•
no-next-header—IPv6 no next header
•
ospf—Open Shortest Path First
•
pim—Protocol Independent Multicast
•
routing—IPv6 routing header
•
rsvp—Resource Reservation Protocol
•
sctp—Stream Control Transmission Protocol
•
tcp—Transmission Control Protocol
•
udp—User Datagram Protocol
•
vrrp—Virtual Router Redundancy Protocol
ipv6-payload-protocol
protocol
(MX Series only) Do not match the IPv6 payload protocol.ipv6-payload-protocol-except
protocol
(MX Series only) Match the IPv6 address in a named-list.ipv6-prefix-list named-list
(MX Series only) 128-bit address that is the originating source node address for this packet.ipv6-source-address address
Copyright © 2017, Juniper Networks, Inc.1076
ACX Series Universal Access Router Configuration Guide