Juniper ACX2000 Configuration Guide

Counters 500 1024 524 0
Policers 0 1024 1024 0
App tcam usage:
----------------
App-Name Entries Counters Policers Precedence State
Related-App-Name ..
-----------------------------------------------------------------
fw-l2-in 500 500 0 2 OK
fw-semantics 0 X X 1 OK
Group: 14, Mode: SINGLE, Hw grps used: 1, Tcam apps: 1
Used Allocated Available Errors
Tcam-Entries 200 512 312 0
Counters 200 512 312 0
Policers 100 512 412 0
App tcam usage:
----------------
App-Name Entries Counters Policers Precedence State
Related-App-Name ..
-----------------------------------------------------------------
fw-ifl-in 200 200 100 1 OK
Tcam Resource Stage: Egress
---------------------------
Free [hw-grps: 3 out of 3]
No dynamic tcam usage
2. Configure additional Layer 2 services on the router.
For example, add 20 more services on the router, thereby increasing the total number
of services to 120. After adding more services, you can check the status of the
configuration by verifying either the syslog message using the command show log
messages, or by running the show pfe tcam errors command.
The following is a sample syslog message output showing the TCAM resource shortage
for Ethernet-switching family filters for newer configurations by running the show log
messages CLI command.
[Sat Jul 11 16:10:33.794 LOG: Err] ACX Error
(dfw):acx_dfw_check_phy_slice_availability :Insufficient phy slices to
accomodate grp:13/IN_IFF_BRIDGE mode:1/DOUBLE
[Sat Jul 11 16:10:33.794 LOG: Err] ACX Error
(dfw):acx_dfw_check_resource_availability :Could not write filter:
f-bridge-ge-0/0/0.103-i, insufficient TCAM resources
[Sat Jul 11 16:10:33.794 LOG: Err] ACX Error (dfw):acx_dfw_update_filter_in_hw
:acx_dfw_check_resource_availability failed for filter:f-bridge-ge-0/0/0.103-i
[Sat Jul 11 16:10:33.794 LOG: Err] ACX Error (dfw):acx_dfw_create_hw_instance
:Status:1005 Could not program dfw(f-bridge-ge-0/0/0.103-i)
type(IN_IFF_BRIDGE)! [1005]
[Sat Jul 11 16:10:33.794 LOG: Err] ACX Error (dfw):acx_dfw_bind_shim :[1005]
Could not create dfw(f-bridge-ge-0/0/0.103-i) type(IN_IFF_BRIDGE)
[Sat Jul 11 16:10:33.794 LOG: Err] ACX Error (dfw):acx_dfw_bind :[1000] bind
failed for filter f-bridge-ge-0/0/0.103-i
If you use the show pfe tcam errors all-tcam-stages detail CLI command to verify the
status of the configuration, the output will be as shown below:
1163Copyright © 2017, Juniper Networks, Inc.
Chapter 34: Configuring Operations, Administration, and Management (OAM)

Juniper ACX2000 Specifications

General

Brand	Juniper
Model	ACX2000
Category	Network Router
Language	English