Juniper ACX2000

-----------------------------------------------------------------
fw-l2-in 500 500 0 2 OK
fw-semantics 0 X X 1 OK
Group: 14, Mode: SINGLE, Hw grps used: 1, Tcam apps: 1
Used Allocated Available Errors
Tcam-Entries 200 512 312 0
Counters 200 512 312 0
Policers 100 512 412 0
App tcam usage:
----------------
App-Name Entries Counters Policers Precedence State
Related-App-Name ..
-----------------------------------------------------------------
fw-ifl-in 200 200 100 1 OK
Tcam Resource Stage: Egress
---------------------------
Free [hw-grps: 3 out of 3]
No dynamic tcam usage
To view TCAM resource usage errors for all stages (egress, ingress, and pre-ingress),
use the show pfe tcam errors all-tcam-stages command.
user@host> show pfe tcam errors all-tcam-stages detail
Slot 0
Tcam Resource Stage: Pre-Ingress
--------------------------------
No tcam usage
Tcam Resource Stage: Ingress
----------------------------
Group: 11, Mode: SINGLE, Hw grps used: 3, Tcam apps: 2
Errors Resource-Shortage
Tcam-Entries 0 0
Counters 0 0
Policers 0 0
Group: 8, Mode: DOUBLE, Hw grps used: 2, Tcam apps: 1
Errors Resource-Shortage
Tcam-Entries 18 0
Counters 0 0
Policers 0 0
Group: 14, Mode: SINGLE, Hw grps used: 1, Tcam apps: 1
Errors Resource-Shortage
Tcam-Entries 0 0
Counters 0 0
Policers 0 0
Tcam Resource Stage: Egress
---------------------------
No tcam usage
You can see that all the applications using the TCAM resources are in OK state and
indicates that the hardware has been successfully configured.
Copyright © 2017, Juniper Networks, Inc.1166
ACX Series Universal Access Router Configuration Guide