Juniper ACX2000

Table 95: jnxSoamDmCfgTable (continued)
DescriptionObject IDObject
Indicates the version of the PDUs used to
perform Delay Measurement.
Version 0 indicates the PDU formats defined
in Y.1731-2008.
Version 1 indicates the PDU formats defined
in Y.1731-2011.
The exact PDUs to use are specified by this
object in combination with
jnxSoamDmCfgType.
This object can only be written at row
creation time and cannot be modified once
it has been created.
jnxSoamDmCfgEntry 3jnxSoamDmCfgVersion
Specifies whether the Delay Measurement
session is enabled.
The value 'true' indicates the Delay
Measurement session is enabled and SOAM
PDUs are sent and/or measurements are
collected when the session is running
according to the scheduling objects (start
time, stop time, etc.).
The value 'false' indicates the Delay
Measurement session is disabled and SOAM
PDUs are not sent and/or measurements
collected.
For a Delay Measurement session to be
removed the row is deleted in order to
release internal resources.
This object can written/modified after row
creation time.
If the DM session is enabled it resumes after
shutdown/restart. If the DM session is
disabled the current Measurement Interval
is stopped, if it in process at the time, and
all the in process calculations for the
partially completed Measurement Interval
are finalized.
This object does not affect whether the
single-ended Responder is enabled or not,
which is enabled or disabled by the
jnxSoamPmMepDmSingleEndedResponder
object.
jnxSoamDmCfgEntry 4jnxSoamDmCfgEnabled
1193Copyright © 2017, Juniper Networks, Inc.
Chapter 34: Configuring Operations, Administration, and Management (OAM)