Juniper ACX2000 Configuration Guide

Incoming label: 299872, Outgoing label: 800002
Negotiated PW status TLV: No
Local interface: ge-2/0/6.0, Status: Up, Encapsulation: ETHERNET
Neighbor: 192.0.2.4
Interface Type St Time last up # Up trans
ge-2/0/6.0(vc 200) rmt ST
2. On Router PE1 and Router PE2, use the show ldp neighbor command to verify that
the targeted LDP sessions have been created between the loopback interface to
the primary and backup H-VPLS hub neighbors.
user@PE1> show ldp neighbor
Address Interface Label space ID Hold time
10.10.3.2 ge-2/0/9.0 192.0.2.2:0 13
10.10.1.2 ge-2/0/10.0 192.0.2.3:0 10
192.0.2.3 lo0.0 192.0.2.3:0 36
192.0.2.4 lo0.0 192.0.2.4:0 39
10.10.9.2 ge-2/0/8.0 192.0.2.4:0 14
user@PE2> show ldp neighbor
Address Interface Label space ID Hold time
10.10.3.1 ge-2/0/10.0 192.0.2.1:0 12
10.10.5.2 ge-2/0/9.0 192.0.2.4:0 11
10.10.4.1 ge-2/0/8.0 192.0.2.3:0 11
192.0.2.3 lo0.0 192.0.2.3:0 39
192.0.2.4 lo0.0 192.0.2.4:0 38
3. On Router PE3 and Router PE4, use the show vpls connections command to verify
that the VPLS connection status is Up for both the LDP-based VPLS and the
BGP-based VPLS Layer 2 circuits that are terminated.
user@PE3> show vpls connections
Layer-2 VPN connections:
Legend for connection status (St)
EI -- encapsulation invalid NC -- interface encapsulation not CCC/TCC/VPLS
EM -- encapsulation mismatch WE -- interface and instance encaps not same
VC-Dn -- Virtual circuit down NP -- interface hardware not present
CM -- control-word mismatch -> -- only outbound connection is up
CN -- circuit not provisioned <- -- only inbound connection is up
OR -- out of range Up -- operational
OL -- no outgoing label Dn -- down
LD -- local site signaled down CF -- call admission control failure
RD -- remote site signaled down SC -- local and remote site ID collision
LN -- local site not designated LM -- local site ID not minimum designated
RN -- remote site not designated RM -- remote site ID not minimum designated
XX -- unknown connection status IL -- no incoming label
MM -- MTU mismatch MI -- Mesh-Group ID not available
BK -- Backup connection ST -- Standby connection
PF -- Profile parse failure PB -- Profile busy
RS -- remote site standby SN -- Static Neighbor
LB -- Local site not best-site RB -- Remote site not best-site
VM -- VLAN ID mismatch
Legend for interface status
Up -- operational
Dn -- down
1291Copyright © 2017, Juniper Networks, Inc.
Chapter 35: Configuring Virtual Private LAN Service

Juniper ACX2000 Specifications

General

Brand	Juniper
Model	ACX2000
Category	Network Router
Language	English