Juniper ACX2000 - Page 1353

user@PE2> show route table l2circuit.0
l2circuit.0: 4 destinations, 4 routes (4 active, 0 holddown, 0 hidden)
+ = Active Route, - = Last Active, * = Both
192.0.2.3:NoCtrlWord:5:200:Local/96
*[L2CKT/7] 00:13:13, metric2 1
> to 10.10.4.1 via ge-2/0/8.0
192.0.2.3:NoCtrlWord:5:200:Remote/96
*[LDP/9] 00:13:13
Discard
192.0.2.4:NoCtrlWord:5:200:Local/96
*[L2CKT/7] 00:13:13, metric2 1
> to 10.10.5.2 via ge-2/0/9.0
192.0.2.4:NoCtrlWord:5:200:Remote/96
*[LDP/9] 00:13:13
Discard
user@PE3> show route table H-VPLS.l2vpn.0
H-VPLS.l2vpn.0: 2 destinations, 2 routes (2 active, 0 holddown, 0 hidden)
+ = Active Route, - = Last Active, * = Both
192.0.2.3:33:3:1/96
*[L2VPN/170/-101] 03:19:26, metric2 1
Indirect
192.0.2.4:44:4:1/96
*[BGP/170] 03:15:45, localpref 100, from 192.0.2.4
AS path: I, validation-state: unverified
> to 10.10.6.2 via ge-2/0/9.0
user@PE4> show route table H-VPLS.l2vpn.0
H-VPLS.l2vpn.0: 2 destinations, 2 routes (2 active, 0 holddown, 0 hidden)
+ = Active Route, - = Last Active, * = Both
192.0.2.3:33:3:1/96
*[BGP/170] 03:21:17, localpref 100, from 192.0.2.3
AS path: I, validation-state: unverified
> to 10.10.6.1 via ge-2/0/9.0
192.0.2.4:44:4:1/96
*[L2VPN/170/-101] 03:17:47, metric2 1
Indirect
Results The configuration and verification parts of this example have been completed. The
following section is for your reference.
The relevant sample configuration for Router PE1 follows.
Router PE1 interfaces {
ge-2/0/5 {
encapsulation ethernet-ccc;
unit 0 {
description to_CE1;
family ccc;
}
}
ge-2/0/8 {
unit 0 {
1295Copyright © 2017, Juniper Networks, Inc.
Chapter 35: Configuring Virtual Private LAN Service