EasyManuals Logo

Juniper ACX2000 Configuration Guide

Juniper ACX2000
3270 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #1411 background imageLoading...
Page #1411 background image
cross-connect (CCC) as the family. If you do not configure the destination IPv4 address,
the default value of 192.168.1.20 is used.
[edit services rpm rfc2544-benchmarking tests test-name test1]
user@host# set destination-ipv4-address address
9. Specify the source MAC address used in generated test frames. This parameter is
effective for a CCC family and it is not applicable for an inet family. If you specify this
parameter for an inet family, a commit error occurs when you commit the configuration.
This parameter is optional for a CCC family. If you do not configure the destination
MAC address, the default value of 0x00:0x60:0x67:0x71:0xC6:0x62 is used.
[edit services rpm rfc2544-benchmarking tests test-name test1]
user@host# set source-mac-address address
10. Specify the destination MAC address used in generated test frames.
[edit services rpm rfc2544-benchmarking tests test-name test1]
user@host# set destination-mac-address address
11. Specify the logical interface on which the RFC 2544-based benchmarking test is run.
This is a local user-to-network interface (UNI) on behalf of which the test frames are
generated when the test direction is egress.
[edit services rpm rfc2544-benchmarking tests test-name test1]
user@host# set test-interface interface-name
12. Specify the service type as E-LINE or E-LAN.
[edit services rpm rfc2544-benchmarking tests test-name test1]
user@host# set service-type eline | elan
13. Specify the forwarding class to be used for test frames. The forwarding class specifies
the manner in which the test frames are processed by the Packet Forwarding Engine
of the router. If you do not configure this parameter, test frames are treated as
best-effort traffic.
[edit services rpm rfc2544-benchmarking tests test-name test1]
user@host# set forwarding-class class-name
14. Configure the address type family for the benchmarking test. The inet option indicates
that the test is run on an IPv4 service. The ccc option indicates that the test is run on
an CCC or Ethernet pseudowire service. The direction statement that you configured
in Step 7 specifies the direction (ingress or egress) to be used for the test.
[edit services rpm rfc2544-benchmarking tests test-name test1]
user@host# set family inet
15. Specify the EtherType to be used for reflection of the test frames, which is a two-octet
field in an Ethernet frame that defines the protocol encapsulated in the frame payload.
This parameter is valid only if you configured the test mode to be a reflector. If you do
not configure this parameter, all EtherTypes are reflected. Use an EtherType value
1353Copyright © 2017, Juniper Networks, Inc.
Chapter 37: Configuring RFC 2544-Based Benchmarking Tests

Table of Contents

Other manuals for Juniper ACX2000

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Juniper ACX2000 and is the answer not in the manual?

Juniper ACX2000 Specifications

General IconGeneral
BrandJuniper
ModelACX2000
CategoryNetwork Router
LanguageEnglish

Related product manuals