[edit interfaces ge-0/0/0]
user@host# edit unit 0
5. Specify the encapsulation for Ethernet VLAN circuits.
[edit interfaces ge-0/0/0 unit 0]
user@host# set encapsulation vlan-ccc
6. Configure the VLAN ID on the logical interface.
[edit interfaces ge-0/0/0 unit 0]
user@host# set vlan-id 101
7. Go to the top level of the configuration command mode.
[edit interfaces ge-0/0/0 unit 0]
user@host# top
8. In configuration mode, go to the [edit services] hierarchy level.
[edit]
user@host# edit services
9. Configure a real-time performance monitoring service (RPM) instance.
[edit services]
user@host# edit rpm
10. Configure an RFC 2544-based benchmarking test for the RPM instance.
[edit services rpm]
user@host# edit rfc2544-benchmarking
11. Define a name for a test profile—for example, throughput.
[edit services rpm rfc2544-benchmarking]
user@host# edit profiles test-profile throughput
12. Configure the type of test to be performed as throughput.
[edit services rpm rfc2544-benchmarking profiles test-profile throughput]
user@host# set test-type throughput
13. Specify the size of the test packet as 64 bytes.
[edit services rpm rfc2544-benchmarking profiles test-profile throughput]
user@host# set test-type packet-size 64
14. Specify the period—for example, 20 minutes—for which the test is to be performed
in hours, minutes, or seconds by specifying a number followed by the letter h (for
hours), m (for minutes), or s (for seconds).
[edit services rpm rfc2544-benchmarking profiles test-profile throughput]
Copyright © 2017, Juniper Networks, Inc.1370
ACX Series Universal Access Router Configuration Guide
To Next Page
Loading...
Need help?
General
