Juniper ACX2000

user@host# set sample-rate number
5. (Optional) You can also configure the polling interval and sample rate at the interface
level:
[edit protocols sflow]
user@host# set interfaces interface-name polling-interval seconds sample-rate number
NOTE: The interface-level configuration overrides the global configuration
for the specified interface.
You can use the following CLI commands to verify and troubleshoot the configurations:
•
show sflow—Display sFlow configuration information.
•
show sflow interface—Display the interfaces on which sFlow is enabled and the sampling
parameters for the interface.
•
show sflow collector—Display a list of configured sFlow collectors and their properties.
•
clear sflow collector statistics—Clear the sample counters for all sFlow collectors.
Related
Documentation
• Overview of sFlow Technology on page 1397
Copyright © 2017, Juniper Networks, Inc.1400
ACX Series Universal Access Router Configuration Guide