defaults—Specify global aggregate route options. These options only set default attributes
inherited by all newly created aggregate routes. These are treated as global defaults
and apply to all the aggregate routes you configure in the aggregate statement. This
part of the aggregate statement is optional.
route destination-prefix—Configure a nondefault aggregate route:
• default—For the default route to the destination. This is equivalent to specifying an IP
address of 0.0.0.0/0.
• destination-prefix/prefix-length—destination-prefix is the network portion of the IP
address, and prefix-length is the destination prefix length.
The policy statement is explained separately.
Required Privilege
Level
routing—To view this statement in the configuration.
routing-control—To add this statement to the configuration.
Related
Documentation
• Example: Summarizing Static Routes Through Route Aggregation
1421Copyright © 2017, Juniper Networks, Inc.
Chapter 41: Configuration Statements
To Next Page
Loading...
Need help?
General
