To Next Page

To Previous Page

atm-snap—(All interfaces including MX Series routers with MPC/MIC interfaces using

the ATM MIC with SFP) Use ATM subnetwork attachment point (SNAP)

encapsulation.

atm-tcc-snap—Use ATM SNAP encapsulation on translational cross-connect (TCC)

circuits.

atm-tcc-vc-mux—Use ATM VC multiplex encapsulation on TCC circuits. When you use

this encapsulation type, you can configure the tcc family only.

atm-vc-mux—(All interfaces including MX Series routers with MPC/MIC interfaces using

the ATM MIC with SFP) Use ATM VC multiplex encapsulation. When you use this

encapsulation type, you can configure the inet family only.

ether-over-atm-llc—(All IP interfaces including MX Series routers with MPC/MIC interfaces

using the ATM MIC with SFP) For interfaces that carry IP traffic, use Ethernet over

ATM LLC encapsulation. When you use this encapsulation type, you cannot configure

multipoint interfaces.

ether-vpls-over-atm-llc—For ATM2 IQ interfaces only, use the Ethernet virtual private

LAN service (VPLS) over ATM LLC encapsulation to bridge Ethernet interfaces and

ATM interfaces over a VPLS routing instance (as described in RFC 2684, Multiprotocol

Encapsulation over ATM Adaptation Layer 5). Packets from the ATM interfaces are

converted to standard ENET2/802.3 encapsulated Ethernet frames with the frame

check sequence (FCS) field removed.

ether-vpls-over-fr—For E1, T1, E3, T3, and SONET interfaces only, use the Ethernet virtual

private LAN service (VPLS) over Frame Relay encapsulation to support Bridged

Ethernet over Frame Relay encapsulated TDM interfaces for VPLS applications, per

RFC 2427, Multiprotocol Interconnect over Frame Relay.

NOTE: The SONET/SDH OC3/STM1 (Multi-Rate) MIC with SFP, the

Channelized SONET/SDH OC3/STM1 (Multi-Rate) MIC with SFP, and the

DS3/E3 MIC do not support Ethernet over Frame Relay encapsulation.

ether-vpls-over-ppp—For E1, T1, E3, T3, and SONET interfaces only, use the Ethernet

virtual private LAN service (VPLS) over Point-to-Point Protocol (PPP) encapsulation

to support Bridged Ethernet over PPP-encapsulated TDM interfaces for VPLS

applications.

ethernet—Use Ethernet II encapsulation (as described in RFC 894, A Standard for the

Transmission of IP Datagrams over Ethernet Networks).

ethernet-ccc—Use Ethernet CCC encapsulation on Ethernet interfaces.

ethernet-vpls—Use Ethernet VPLS encapsulation on Ethernet interfaces that have VPLS

enabled and that must accept packets carrying standard Tag Protocol ID (TPID)

values.

ACX Series Universal Access Router Configuration Guide

Juniper ACX2000 Configuration Guide

Other manuals for Juniper ACX2000