vlan-bridge—Use Ethernet VLAN bridge encapsulation on Ethernet interfaces that have
IEEE 802.1Q tagging, flexible-ethernet-services, and bridging enabled and that must
accept packets carrying TPID 0x8100 or a user-defined TPID.
vlan-ccc—Use Ethernet virtual LAN (VLAN) encapsulation on CCC circuits. When you use
this encapsulation type, you can configure the ccc family only.
vlan-vci-ccc—Use ATM-to-Ethernet interworking encapsulation on CCC circuits. When
you use this encapsulation type, you can configure the ccc family only.
vlan-tcc—Use Ethernet VLAN encapsulation on TCC circuits. When you use this
encapsulation type, you can configure the tcc family only.
vlan-vpls—Use Ethernet VLAN encapsulation on VPLS circuits.
vxlan—Use VXLAN data plane encapsulation for EVPN.
Required Privilege
Level
interface—To view this statement in the configuration.
interface-control—To add this statement to the configuration.
Related
Documentation
• Configuring Layer 2 Switching Cross-Connects Using CCC
• Configuring the Encapsulation for Layer 2 Switching TCCs
• Configuring Interface Encapsulation on Logical Interfaces
• Configuring MPLS LSP Tunnel Cross-Connects Using CCC
• Circuit and Translational Cross-Connects Overview
• Identifying the Access Concentrator
• Configuring ATM Interface Encapsulation
• Configuring VLAN and Extended VLAN Encapsulation
• Configuring ATM-to-Ethernet Interworking
• Configuring Interface Encapsulation on PTX Series Packet Transport Routers
• Configuring CCC Encapsulation for Layer 2 VPNs
• Configuring TCC Encapsulation for Layer 2 VPNs and Layer 2 Circuits
• Configuring ATM for Subscriber Access
• Understanding CoS on ATM IMA Pseudowire Interfaces Overview on page 895
• Configuring Policing on an ATM IMA Pseudowire on page 912
Copyright © 2017, Juniper Networks, Inc.1510
ACX Series Universal Access Router Configuration Guide
To Next Page
