To Next Page

To Previous Page

Description Select which packet header data to use for per-flow load balancing.

The options are explained separately.

NOTE: To modify the default hashing mechanism on Modular Port

Concentrators (MPCs) and Type 5 FPCs, you need to configure the statements

at the [edit forwarding-optionsenhanced-hash-key] hierarchy level. Statements

at the [edit forwarding-options hash-key] hierarchy level do not support MPCs

and Type 5 FPCs.

NOTE:

The following statements are not supported on T Series routers:

• The symmetric-hash and the session-id statements at the [edit

forwarding-options hash-key family inet] hierarchy level and all statements

at the [edit forwarding-options hash-key family multiservice] hierarchy level.

• The label-1 and label-2 statements, and the IP configuration at the [edit

forwarding-options hash-key family multiservice] hierarchy level.

NOTE: The following statements are not supported on Q Series switches:

• The symmetric-hash and the session-id statements at the [edit

forwarding-options hash-key family inet] hierarchy level.

Required Privilege

Level

interface—To view this statement in the configuration.

interface-control—To add this statement to the configuration.

Documentation

• Configuring Per-Packet Load Balancing on page 790

• Configuring Load Balancing Based on MPLS Labels

• Configuring Load Balancing Based on MAC Addresses on page 798

ACX Series Universal Access Router Configuration Guide

Juniper ACX2000 Configuration Guide

Other manuals for Juniper ACX2000