authentication-key-chain key-chain—(Optional) Authentication keychain password. It
can be up to 126 characters. Characters can include any ASCII strings. If you include
spaces, enclose all characters in quotation marks (“ ”).
local-address ip-address—(Optional) IP address of the local end of the PCEP session,
the PCC.
lsp-retry-delegation—(Optional) Enable retry LSP delegation process.
lsp-retry-delegation-timer—(Optional) Specify the amount of time (in seconds) that
the Path Computation Client (PCC) must wait before retrying delegation of Path
Computation Element (PCE)-initiated LSPs in case of delegation failure or
re-delegation.
Default: 3600 seconds
Range: 0 through 4294967294 seconds
max-sid-depth—(Optional) Specify the maximum value for service identifier (SID) depth.
Default: 5
Range: 1 through 5
p2mp-lsp-report-capability—(Optional) Capability to report point-to-multipoint RSVP-TE
LSPs to a PCE. By default, this capability is not supported on a PCC, and should be
explicitly configured to enable reporting of point-to-multipoint LSPs to a PCE.
spring-capability—(Optional) Enable SPRING-based provisioning for the PCE.
Required Privilege
Level
routing—To view this statement in the configuration.
routing-control—To add this statement to the configuration.
Related
Documentation
• pcep on page 1657
• Example: Configuring Path Computation Element Protocol for SPRING-TE LSPs
• Support of the Path Computation Element Protocol for RSVP-TE Overview on page 692
Copyright © 2017, Juniper Networks, Inc.1656
ACX Series Universal Access Router Configuration Guide
To Next Page
Loading...
Need help?
General
