Juniper ACX2000

dnat-44—Translate the destination address statically (IPv4 to IPv4).
dynamic-nat44—Translate only the source address by dynamically choosing the NAT
address from the source address pool.
napt-44—Translate the transport identifier of the IPv4 private network to a single IPv4
external address.
napt-66—Translate the transport identifier of the IPv6 private network to a single IPv6
external address.
napt-pt—Bind addresses in an IPv6 network with addresses in an IPv4 network and vice
versa to provide transparent routing for the datagrams traversing between the
address realms.
nptv6—Translate the source address prefix in a stateless manner (IPv6 to IPv6).
stateful-nat464—Implement 464XLAT Provider-Side Translater (PLAT) address
translation for source IP addresses and IPv6 prefix removal translation for destination
IPv4 addresses.
stateful-nat64—Implement dynamic address and port translation for source IP addresses
(IPv6-to-IPv4) and prefix removal translation for the destination IP addresses
(IPv6-to-IPv4).
twice-basic-nat-44—Translate the source and destination addresses statically (IPv4
to IPv4).
NOTE: Starting with Junos OS Release 15.1R1, the twice NAT functionality
(twice-basic-nat-44, twice-dynamic-nat-44, and twice-dynamic-napt-44
options) is supported on MX Series routers with MS-MPCs and MS-MICs.
twice-dynamic-nat-44—Translate the source address by dynamically choosing the NAT
address from the source address pool. Translate the destination address statically.
twice-dynamic-napt-44—Translate the transport identifier of the IPv4 private network
to a single IPv4 external address. Translate the destination address statically.
Required Privilege
Level
interface—To view this statement in the configuration.
interface-control—To add this statement to the configuration.
Related
Documentation
• Network Address Translation Rules Overview
Copyright © 2017, Juniper Networks, Inc.1760
ACX Series Universal Access Router Configuration Guide