fan fantray-slot-number—(MX2010, MX2020, and MX2008 routers only) (Optional)
Display chassis environmental information for the fan trays. Replace
fantray-slot-number with a value from 0 through 3.
fpc fpc-slot—(EX Series switches, M120, M320, and M40e routers, MX Series routers,
MX2010 routers, MX2020 routers, MX2008 routers, PTX Series Packet Transport
Routers, QFX Series, QFX3500 switches, QFabric systems, T Series routers, and TX
Matrix Plus routers) (Optional) Display chassis environmental information for a
specified Flexible PIC Concentrator. For MX2010 and MX2008 routers, replace fpc-slot
with a value from 0 through 9. For MX2020 routers, replace fpc-slot with a value
from 0 through 19. For information about FPC numbering, see show chassis
environment fpc. On a QFabric system, display chassis environmental information
for a specified Flexible PIC Concentrator on an Interconnect device. On an EX Series
switch, display chassis environmental information for a specified Flexible PIC
Concentrator; see the hardware documentation for your switch for information on
FPC numbering. On a TX Matrix Plus router with 3D SIBs replace fpc-slot with a value
from 0 through 63.
fpm—(M120, M320, and M40e routers, MX2010 routers, MX2020 routers, MX2008 routers,
PTX Series, Packet Transport Routers, T Series routers, and TX Matrix Plus routers
only) (Optional) Display chassis environmental information for the craft interface
(FPM).
interconnect-device name—(QFabric systems only) (Optional) Display chassis
environmental information for the Interconnect device.
lcc number—(TX Matrix routers and TX Matrix Plus routers only) (Optional) Line-card
chassis number.
Replace number with the following values depending on the LCC configuration:
• 0 through 3, when T640 routers are connected to a TX Matrix router in a routing
matrix.
• 0 through 3, when T1600 routers are connected to a TX Matrix Plus router in a
routing matrix.
• 0 through 7, when T1600 routers are connected to a TX Matrix Plus router with 3D
SIBs in a routing matrix.
• 0, 2, 4, or 6, when T4000 routers are connected to a TX Matrix Plus router with
3D SIBs in a routing matrix.
local—(MX Series routers and EX Series switches only) (Optional) Display chassis
environmental information for the local Virtual Chassis member.
member member-id—(MX Series routers and EX Series switches only) (Optional) Display
chassis environmental information for the specified member of the Virtual Chassis
configuration. On MX Series routers, replace member-id with a value of 0 or 1. For EX
Series switches, see member for member ID values.
1887Copyright © 2017, Juniper Networks, Inc.
Chapter 42: Operational Commands
To Next Page
Loading...
Need help?
General
