Syntax (OCX Series) show chassis environment pem
<slot>
Release Information Command introduced before Junos OS Release 7.4.
Command introduced in Junos OS Release 11.3 for the QFX Series.
Command introduced in Junos OS Release 12.3R2 for EX Series.
Command introduced in Junos OS Release 13.2 for MX104 3D Universal Edge Routers.
Command introduced in Junos OS Release 14.1X53-D20 for the OCX Series.
satellite option introduced in Junos OS Release 14.2R3.
Command introduced in Junos OS Release 17.2 for vMX on NFX250 Network Services
Platform.
Command introduced in Junos OS Release 17.2 for PTX10008 Routers.
Command introduced in Junos OS Release 17.3 for MX10003 3D Universal Edge Routers.
Description Display Power Entry Module (PEM) environmental status information.
NOTE: The new high-capacity (4100W) enhanced DC PEM on MX960 routers
includes a new design that can condition the input voltage. This results in
the output voltage differing from the input voltage. The earlier generation of
DC PEMs coupled the input power directly to the output, thereby making it
safe to assume that the output voltage was equal to the input voltage.
Options none—Display environmental information about both PEMs. For the TX Matrix router,
display environmental information about the PEMs, the TX Matrix router, and its
attached T640 routers. For the TX Matrix Plus router, display environmental
information about the PEMs, the TX Matrix Plus router, and its attached routers.
all-members—(MX Series routers only) (Optional) Display environmental information
about the PEMs in all the member routers of the Virtual Chassis configuration.
interconnect-device name—(QFabric systems only) (Optional) Display chassis
environmental information about the PEMs in the Interconnect device.
lcc number—(TX Matrix router and TX Matrix Plus router only) (Optional) Line-card
chassis number.
Replace number with the following values depending on the LCC configuration:
• 0 through 3, when T640 routers are connected to a TX Matrix router in a routing
matrix.
• 0 through 3, when T1600 routers are connected to a TX Matrix Plus router in a
routing matrix.
• 0 through 7, when T1600 routers are connected to a TX Matrix Plus router with 3D
SIBs in a routing matrix.
• 0, 2, 4, or 6, when T4000 routers are connected to a TX Matrix Plus router with
3D SIBs in a routing matrix.
1995Copyright © 2017, Juniper Networks, Inc.
Chapter 42: Operational Commands
To Next Page
Loading...
Need help?
General
