Juniper ACX2000 Configuration Guide

Syntax (ACX5048 and
ACX5096 Routers)
show chassis mac-addresses
Syntax (ACX500
Routers)
show chassis mac-addresses
Release Information Command introduced before JUNOS Release 7.4.
Command introduced in JUNOS Release 9.0 for EX Series switches.
sfc option introduced for the TX Matrix Plus router in JUNOS Release 9.6.
Command introduced in Junos OS Release 11.1 for QFX Series.
Command introduced in Junos OS Release 12.2 for ACX Series Universal Access Routers.
Command introduced in Junos OS Release 12.3 for MX2020 3D Universal Edge Routers.
Command introduced in Junos OS Release 12.3 for MX2010 3D Universal Edge Routers.
Command introduced in Junos OS Release 15.1X54-D20 for ACX5048 and ACX5096
Routers.
Command introduced in Junos OS Release 17.2 for vMX on NFX250 Network Services
Platform.
Command introduced in Junos OS Release 17.2 for MX2008 3D Universal Edge Routers.
Command introduced in Junos OS Release 17.2 for PTX10008 Routers.
Command introduced in Junos OS Release 17.3 for MX10003 3D Universal Edge Routers.
Description Display the media access control (MAC) addresses for the router, switch chassis, or
switch.
Options none—(TX Matrix, TX Matrix Plus routers, QFX Series, and OCX Series Switches) Display
the MAC addresses for the router chassis or switch. On a TX Matrix router, display
MAC addresses on the TX Matrix router and its attached T640 routers. On a TX
Matrix Plus router, display MAC addresses on the TX Matrix Plus router and its
attached routers.
all-members—(MX Series routers only) (Optional) Display the MAC addresses for all
the member routers of the Virtual Chassis configuration.
interconnect-device name—(QFabric switches only) (Optional) Display the MAC
addresses for the Interconnect device.
lcc number—(TX Matrix and TX Matrix Plus routers only) (Optional) On a TX Matrix router,
display MAC addresses for a specified T640 router (or line-card chassis) that is
connected to the TX Matrix Plus router. On a TX Matrix Plus router, display MAC
addresses for a specified router (line-card chassis) that is connected to the TX Matrix
Plus router.
Replace number with the following values depending on the LCC configuration:
• 0 through 3, when T640 routers are connected to a TX Matrix router in a routing
matrix.
• 0 through 3, when T1600 routers are connected to a TX Matrix Plus router in a
routing matrix.
2327Copyright © 2017, Juniper Networks, Inc.
Chapter 42: Operational Commands

Juniper ACX2000 Specifications

General

Brand	Juniper
Model	ACX2000
Category	Network Router
Language	English