Juniper ACX2000

Table 144: ATM show interfaces Output Fields (continued)
Level of OutputField DescriptionField Name
extensiveActive alarms and defects, plus counts of specific SDH errors with detailed
information.
• Seconds—Number of seconds the defect has been active.
• Count—Number of times that the defect has gone from inactive to active.
• State—State of the error. State other than OK indicates a problem.
Subfields are:
• MS-BIP24—8-bit BIP for high-order path overhead (B3 byte)
• MS-FEBE—Far-end block error (multiplex section)
• MS-FERF—Far-end remote fail (multiplex section)
• MS-AIS—Alarm indication signal (multiplex section)
• BERR-SF—Bit error rate fault (signal failure)
• BERR-SD—Bit error rate defect (signal degradation)
• MS-ES—Errored seconds (near-end multiplex section)
• MS-SES—Severely errored seconds (near-end multiplex section)
• MS-UAS—Unavailable seconds (near-end multiplex section)
• MS-ES-FE—Errored seconds (far-end multiplex section)
• MS-SES-FE—Severely errored seconds (far-end multiplex section)
• MS-UAS-FE—Unavailable seconds (far-end multiplex section)
SDH multiplex
section
extensiveActive alarms and defects, plus counts of specific SDH errors with detailed
information.
• Seconds—Number of seconds the defect has been active.
• Count—Number of times that the defect has gone from inactive to active.
• State—State of the error. State other than OK indicates a problem.
Subfields are:
• HP-BIP8—8-bit BIP for regenerator section overhead (B1 byte)
• HP-FEBE—Far-end block error (high-order path)
• HP-LOP—Loss of pointer (high-order path)
• HP-AIS—High-order-path alarm indication signal
• HP-FERF—Far-end remote fail (high-order path)
• HP-UNEQ—Unequipped (high-order path)
• HP-PLM—Payload label mismatch (high-order path)
• HP-ES—Errored seconds (near-end high-order path)
• HP-SES—Severely errored seconds (near-end high-order path)
• HP-UAS—Unavailable seconds (near-end high-order path)
• HP-ES-FE—Errored seconds (far-end high-order path)
• HP-SES-FE—Severely errored seconds (far-end high-order path)
• HP-UAS-FE—Unavailable seconds (far-end high-order path)
SDH path
Copyright © 2017, Juniper Networks, Inc.2478
ACX Series Universal Access Router Configuration Guide