Juniper ACX2000 Configuration Guide

1 expedited-fo 0 0 0
2 assured-forw 0 0 0
3 network-cont 40 40 0
DS1 alarms : None
DS1 defects : None
DS1 BERT configuration:
BERT time period: 10 seconds, Elapsed: 0 seconds
Induced Error rate: 10e-0, Algorithm: 2^15 - 1
Logical interface t1-1/1/0.0 (Index 66) (SNMP ifIndex 51) (Generation 5)
Flags: Hardware-Down Point-To-Point SNMP-Traps Encapsulation: PPP
Protocol inet, MTU: 1500, Generation: 14, Route table: 0
Flags: Protocol-Down
Addresses, Flags: Dest-route-down Is-Preferred Is-Primary
Destination: 198.51.100.0/24, Local: 198.51.100.1, Broadcast:
198.51.100.255,
Generation: 18
show interfaces extensive (T1 CRC Errors)
user@host> show interfaces t1-3/2/0:1:1 extensive
Physical interface: t1-3/2/0:1:1, Enabled, Physical link is Down
Interface index: 179, SNMP ifIndex: 79, Generation: 180
:
:
DS1 alarms : AIS, LOF, CRC Major, CRC Minor
DS1 defects : AIS, LOF, CRC Major, CRC Minor
T1 media: Seconds Count State
SEF 1 1 OK
BEE 1 1 OK
AIS 1128 1 Defect Active
LOF 1128 1 Defect Active
LOS 0 0 OK
YELLOW 0 0 OK
CRC Major 154 1 Defect Active
CRC Minor 154 1 Defect Active
BPV 0 0
EXZ 0 0
LCV 0 0
PCV 0 0
CS 0 0
CRC 154 15400
...
show interfaces extensive (T1, PPP)
user@host> show interfaces t1-1/1/0 extensive
Physical interface: t1-1/1/0, Enabled, Physical link is Up
Interface index: 149, SNMP ifIndex: 45, Generation: 32
Link-level type: PPP, MTU: 1504, Clocking: Internal, Speed: T1,
Loopback: None, FCS: 16, Framing: ESF
Device flags : Present Running
Interface flags: Point-To-Point SNMP-Traps Internal: 0x4000
Link flags : Keepalives
Hold-times : Up 0 ms, Down 0 ms
Keepalive settings: Interval 10 seconds, Up-count 1, Down-count 3
Keepalive statistics:
Input : 0 (last seen: never)
Copyright © 2017, Juniper Networks, Inc.2520
ACX Series Universal Access Router Configuration Guide

Juniper ACX2000 Specifications

General

Brand	Juniper
Model	ACX2000
Category	Network Router
Language	English