Table 150: show interfaces Gigabit Ethernet Output Fields
Level of OutputField DescriptionField Name
Physical Interface
All levelsName of the physical interface.Physical interface
All levelsState of the interface. Possible values are described in the “Enabled Field”
section under Common Output Fields Description.
Enabled
detail extensive noneIndex number of the physical interface, which reflects its initialization sequence.Interface index
detail extensive noneSNMP index number for the physical interface.SNMP ifIndex
detail extensiveUnique number for use by Juniper Networks technical support only.Generation
All levelsEncapsulation being used on the physical interface.Link-level type
All levelsMaximum transmission unit size on the physical interface.MTU
All levelsSpeed at which the interface is running.Speed
All levelsLoopback status: Enabled or Disabled. If loopback is enabled, type of loopback:
Local or Remote.
Loopback
All levelsSource filtering status: Enabled or Disabled.Source filtering
All levels10-Gigabit Ethernet interface operating in Local Area Network Physical Layer
Device (LAN PHY) mode. LAN PHY allows 10-Gigabit Ethernet wide area links
to use existing Ethernet applications.
LAN-PHY mode
All levels10-Gigabit Ethernet interface operating in Wide Area Network Physical Layer
Device (WAN PHY) mode. WAN PHY allows 10-Gigabit Ethernet wide area links
to use fiber-optic cables and other devices intended for SONET/SDH.
WAN-PHY mode
All levelsUnidirectional link mode status for 10-Gigabit Ethernet interface: Enabled or
Disabled for parent interface; Rx-only or Tx-only for child interfaces.
Unidirectional
All levelsFlow control status: Enabled or Disabled.Flow control
All levels(Gigabit Ethernet interfaces) Autonegotiation status: Enabled or Disabled.Auto-negotiation
All levels(Gigabit Ethernet interfaces) Remote fault status:
• Online—Autonegotiation is manually configured as online.
• Offline—Autonegotiation is manually configured as offline.
Remote-fault
All levelsInformation about the physical device. Possible values are described in the
“Device Flags” section under Common Output Fields Description.
Device flags
All levelsInformation about the interface. Possible values are described in the “Interface
Flags” section under Common Output Fields Description.
Interface flags
Copyright © 2017, Juniper Networks, Inc.2600
ACX Series Universal Access Router Configuration Guide
To Next Page
Loading...
Need help?
General
