Table 154: show interfaces Fast Ethernet Output Fields (continued)
Level of OutputField DescriptionField Name
All levels(10-Gigabit Ethernet DWDM interfaces only) Displays the frequency associated
with the configured wavelength, in terahertz (THz).
Frequency
detail extensive noneNumber of CoS queues configured.CoS queues
extensive(GigabitEthernet intelligent queuing 2 (IQ2) interfaces only) Number of CoS
schedulers configured.
Schedulers
detail extensiveCurrent interface hold-time up and hold-time down, in milliseconds.Hold-times
detail extensive noneConfigured MAC address.Current address
detail extensive noneHardware MAC address.Hardware address
detail extensive noneDate, time, and how long ago the interface went from down to up. The format
is Last flapped:year-month-day hour:minute:second:timezone (hour:minute:second
ago). For example, Last flapped: 2002-04-26 10:52:40 PDT (04:33:20 ago).
Last flapped
None specifiedInput rate in bits per second (bps) and packets per second (pps).Input Rate
None specifiedOutput rate in bps and pps.Output Rate
detail extensiveTime when the statistics for the interface were last set to zero.Statistics last
cleared
detail extensiveNumber and rate of bytes and packets received and transmitted on the physical
interface.
• Input bytes—Number of bytes received on the interface
• Output bytes—Number of bytes transmitted on the interface.
• Input packets—Number of packets received on the interface.
• Output packets—Number of packets transmitted on the interface.
Gigabit Ethernet and 10-Gigabit Ethernet IQ PICs count the overhead and CRC
bytes.
For Gigabit Ethernet IQ PICs, the input byte counts vary by interface type. For
more information, see Table 31 under the show interfaces (10-Gigabit Ethernet)
command.
Traffic statistics
2651Copyright © 2017, Juniper Networks, Inc.
Chapter 42: Operational Commands
To Next Page
Loading...
Need help?
General
