Table 154: show interfaces Fast Ethernet Output Fields (continued)
Level of OutputField DescriptionField Name
extensive(10-Gigabit Ethernet interfaces, WAN PHY mode) SONET error information:
• Seconds—Number of seconds the defect has been active.
• Count—Number of times that the defect has gone from inactive to active.
• State—State of the error. Any state other than OK indicates a problem.
Subfields are:
• BIP-B1—Bit interleaved parity for SONET section overhead
• SEF—Severely errored framing
• LOL—Loss of light
• LOF—Loss of frame
• ES-S—Errored seconds (section)
• SES-S—Severely errored seconds (section)
• SEFS-S—Severely errored framing seconds (section)
WIS section
extensive(10-Gigabit Ethernet interfaces, WAN PHY mode) Active alarms and defects,
plus counts of specific SONET errors with detailed information.
• Seconds—Number of seconds the defect has been active.
• Count—Number of times that the defect has gone from inactive to active.
• State—State of the error. State other than OK indicates a problem.
Subfields are:
• BIP-B2—Bit interleaved parity for SONET line overhead
• REI-L—Remote error indication (near-end line)
• RDI-L—Remote defect indication (near-end line)
• AIS-L—Alarm indication signal (near-end line)
• BERR-SF—Bit error rate fault (signal failure)
• BERR-SD—Bit error rate defect (signal degradation)
• ES-L—Errored seconds (near-end line)
• SES-L—Severely errored seconds (near-end line)
• UAS-L—Unavailable seconds (near-end line)
• ES-LFE—Errored seconds (far-end line)
• SES-LFE—Severely errored seconds (far-end line)
• UAS-LFE—Unavailable seconds (far-end line)
WIS line
2657Copyright © 2017, Juniper Networks, Inc.
Chapter 42: Operational Commands
To Next Page
Loading...
Need help?
General
