Table 155: Aggregated Ethernet show interfaces Output Fields (continued)
Level of OutputField DescriptionField Name
All levelsState of the physical interface. Possible values are described in the “Enabled
Field” section under Common Output Fields Description.
Enabled
All levelsIndex number of the physical interface, which reflects its initialization sequence.Interface index
detail extensive noneSNMP index number for the physical interface.SNMP ifIndex
detail extensiveUnique number for use by Juniper Networks technical support only.Generation
All levelsEncapsulation being used on the physical interface.Link-level type
All levelsMaximum transmission unit size on the physical interface.MTU
All levelsSpeed at which the interface is running.Speed
All levelsLoopback status: Enabled or Disabled. If loopback is enabled, type of loopback:
Local or Remote.
Loopback
All levelsSource filtering status: Enabled or Disabled.Source filtering
All levelsFlow control status: Enabled or Disabled.Flow control
All levelsNumber of child links that must be operational for the aggregate interface to
be operational.
Minimum links
needed
All levelsInformation about the physical device. Possible values are described in the
“Device Flags” section under Common Output Fields Description.
Device flags
All levelsInformation about the interface. Possible values are described in the “Interfaces
Flags” section under Common Output Fields Description.
Interface flags
detail extensiveConfigured MAC address.Current address
detail extensiveHardware MAC address.Hardware address
detail extensiveDate, time, and how long ago the interface went from down to up or from up
to down. The format is Last flapped: year-month-day hours:minutes:seconds
timezone (hours:minutes:seconds ago). For example, Last flapped: 2002-04-26
10:52:40 PDT (04:33:20 ago).
Last flapped
None specifiedInput rate in bits per second (bps) and packets per second (pps).Input Rate
None specifiedOutput rate in bps and pps.Output Rate
detail extensiveTime when the statistics for the interface were last set to zero.Statistics last
cleared
2667Copyright © 2017, Juniper Networks, Inc.
Chapter 42: Operational Commands
To Next Page
Loading...
Need help?
General
