Juniper ACX2000

Table 155: Aggregated Ethernet show interfaces Output Fields (continued)
Level of OutputField DescriptionField Name
detail extensive noneLACP statistics for each aggregated interface.
• LACP Rx—LACP received counter that increments for each normal hello.
• LACP Tx—Number of LACP transmit packet errors logged.
• Unknown Rx—Number of unrecognized packet errors logged.
• Illegal Rx—Number of invalid packets received.
NOTE: For LACP Rx and LACP Tx, Packet count is updated only on snmp timer
expiry (30 secs).
LACP Statistics
briefProtocol family configured on the logical interface. Possible values are described
in the “Protocol Field” section under Common Output Fields Description.
protocol-family
detail extensive noneProtocol family configured on the logical interface. Possible values are described
in the “Protocol Field” section under Common Output Fields Description.
Protocol
detail extensive noneMaximum transmission unit size on the logical interface.MTU
detail extensive noneMaximum number of MPLS labels configured for the MPLS protocol family on
the logical interface.
Maximum labels
detail extensiveUnique number for use by Juniper Networks technical support only.Generation
detail extensiveRouting table in which the logical interface address is located. For example, 0
refers to the routing table inet.0.
Route Table
detail extensive noneInformation about protocol family flags. Possible values are described in the
“Family Flags Field” section under Common Output Fields Description.
Flags
detail extensive noneNumber of MAC address validation failures for packets and bytes. This field is
displayed when MAC address validation is enabled for the logical interface.
Mac-Validate
Failures
detail extensive noneInformation about address flags. Possible values are described in the “Addresses
Flags” section under Common Output Fields Description.
Addresses, Flags
detail extensive noneIP address of the remote side of the connection.Destination
detail extensive noneIP address of the logical interface.Local
detail extensive noneBroadcast address of the logical interface.Broadcast
detail extensiveUnique number for use by Juniper Networks technical support only.Generation
Sample Output
show interfaces (Aggregated Ethernet)
user@host> show interfaces ae0
2671Copyright © 2017, Juniper Networks, Inc.
Chapter 42: Operational Commands