Juniper ACX2000

Defects:
Remote MEP not receiving CCM : no
Erroneous CCM received : yes
Cross-connect CCM received : no
RDI sent by some MEP : yes
Alarm Indication Signal : yes
Statistics:
CCMs sent : 76
CCMs received out of sequence : 0
LBMs sent : 0
Valid in-order LBRs received : 0
Valid out-of-order LBRs received : 0
LBRs received with corrupted data : 0
LBRs sent : 0
LTMs sent : 0
LTMs received : 0
LTRs sent : 0
LTRs received : 0
Sequence number of next LTM request : 1645032434
1DMs sent : 0
Valid 1DMs received : 0
Invalid 1DMs received : 0
DMMs sent : 0
DMRs sent : 0
Valid DMRs received : 0
Invalid DMRs received : 0
Valid AIS frames transmitted : 0
Valid AIS frames received : 0
SLM sent : 10
Valid SLM received : 20
Invalid SLM received : 0
SLR sent : 20
Valid SLR received : 10
Invalid SLR received : 0
Remote MEP count: 2
Identifier MAC address State Interface
2001 00:90:69:0b:7f:71 ok ge-5/2/9.0
4001 00:90:69:0b:09:c5 ok ge-5/2/9.0
show oam ethernet connectivity-fault-
management interfaces level
user@host> show oam ethernet connectivity-fault-management interfaces level 7
Interface Link Status Level MEP Neighbors
Identifier
ge-3/0/0.0 Up Active 7 201 0
xe-0/0/0.0 Up Active 7 203 1
show oam ethernet connectivity-fault-
management interfaces (trunk ports)
user@host> show oam ethernet connectivity-fault-management interfaces
Interface Link Status Level MEP Neighbors
Identifier
ge-4/0/1.0, vlan 100 Up Active 5 100 0
2777Copyright © 2017, Juniper Networks, Inc.
Chapter 42: Operational Commands