Juniper ACX2000 Configuration Guide

Table 226: show route table Output Fields (continued)
Field DescriptionField Name
Value used to distinguish MoFRR primary and backup routes. A lower weight value is preferred. Among
routes with the same weight value, load balancing is possible.
weight
MPLS label assigned to the Layer 2 circuit virtual connection.VC Label
Maximum transmission unit (MTU) of the Layer 2 circuit.MTU
VLAN identifier of the Layer 2 circuit.VLAN ID
Forwarding equivalent class (FEC) bound to this route. Applicable only to routes installed by LDP.Prefixes bound to route
Community path attribute for the route. See Table 219 on page 3010 for all possible values for this field.Communities
Layer 2 encapsulation (for example, VPLS).Layer2-info: encaps
Control flags: none or Site Down.control flags
Maximum transmission unit (MTU) information.mtu
First label in a block of labels and label block size. A remote PE routing device uses this first label
when sending traffic toward the advertising PE routing device.
Label-Base, range
Layer 2 VPN and VPLS network layer reachability information (NLRI).status vector
Current active path when BGP multipath is configured.Accepted Multipath
The LongLivedStale flag indicates that the route was marked LLGR-stale by this router, as part of the
operation of LLGR receiver mode. Either this flag or the LongLivedStaleImport flag might be displayed
for a route. Neither of these flags is displayed at the same time as the Stale (ordinary GR stale) flag.
Accepted
LongLivedStale
The LongLivedStaleImport flag indicates that the route was marked LLGR-stale when it was received
from a peer, or by import policy. Either this flag or the LongLivedStale flag might be displayed for a
route. Neither of these flags is displayed at the same time as the Stale (ordinary GR stale) flag.
Accept all received BGP long-lived graceful restart (LLGR) and LLGR stale routes learned from
configured neighbors and import into the inet.0 routing table
Accepted
LongLivedStaleImport
Accept all received BGP long-lived graceful restart (LLGR) and LLGR stale routes learned from
configured neighbors and imported into the inet.0 routing table
The LongLivedStaleImport flag indicates that the route was marked LLGR-stale when it was received
from a peer, or by import policy.
ImportAccepted
LongLivedStaleImport
Path currently contributing to BGP multipath.Accepted
MultipathContrib
Local preference value included in the route.Localpref
BGP router ID as advertised by the neighbor in the open message.Router ID
3121Copyright © 2017, Juniper Networks, Inc.
Chapter 42: Operational Commands

Juniper ACX2000 Specifications

General

Brand	Juniper
Model	ACX2000
Category	Network Router
Language	English