Juniper ACX2000

[edit protocols ptp slave interface ge-0/1/0.0 unicast-mode clock-source 10.10.10.50
local-ip-address 10.10.10.75]
user@host# top
[edit]
user@host# edit protocols
[edit protocols]
user@host# show
See the output for the show command in the Results section.
Results
The following output shows the configuration of unicast-negotiation and compensation
for some network asymmetry. The unicast-negotiation statement includes the parameters
for the delay request, announce interval, synchronization interval, and grant duration
values. Interface ge-0/1/0.0 is configured to compensate for an asymmetric path to the
PTP master by subtracting 4.5 microseconds from the slave-to-master direction delay
calculations.
[edit protocols]
user@host# show
ptp {
clock-mode ordinary;
domain 110;
unicast-negotiation;
slave {
delay-request -6;
announce-timeout 2;
announce-interval 3;
sync-interval -5;
grant-duration 7200;
interface ge-0/1/0.0 {
unicast-mode {
transport ipv4;
clock-source 10.10.10.50 local-ip-address 10.10.10.75 {
asymmetry -4500;
}
}
}
}
}
Related
Documentation
IEEE 1588v2 Precision Timing Protocol (PTP) on ACX Series Universal Access Routers
on page 237
•
• slave
• unicast-mode
Copyright © 2017, Juniper Networks, Inc.260
ACX Series Universal Access Router Configuration Guide