Juniper ACX2000

5. Enable MPLS on all interfaces of Router PCC, excluding the management interface.
[edit protocols]
user@PCC# set mpls interface all
user@PCC# set mpls interface fxp0.0 disable
6. Configure IS-IS on all interfaces of Router PCC, excluding the management interface.
[edit protocols]
user@PCC# set isis level 1 disable
user@PCC# set isis interface all
user@PCC# set isis interface fxp0.0 disable
user@PCC# set isis interface lo0.0
7. Define the PCE that Router PCC connects to, and configure the IP address of the
PCE.
[edit protocols]
user@PCC# set pcep pce pce1 destination-ipv4-address 10.209.57.166
8. Configure the destination port for Router PCC that connects to a PCE using the
TCP-based PCEP.
[edit protocols]
user@PCC# set pcep pce pce1 destination-port 4189
9. Configure the PCE type.
[edit protocols]
user@PCC# set pcep pce pce1 pce-type active
user@PCC# set pcep pce pce1 pce-type stateful
Results
From configuration mode, confirm your configuration by entering the show interfaces and
show protocols commands. If the output does not display the intended configuration,
repeat the instructions in this example to correct the configuration.
user@PCC# show interfaces
ge-1/0/1 {
unit 0 {
family inet {
address 20.31.4.1/24;
}
family iso;
family mpls;
}
}
ge-1/1/1 {
unit 0 {
family inet {
address 20.31.1.1/24;
}
Copyright © 2017, Juniper Networks, Inc.714
ACX Series Universal Access Router Configuration Guide