Action From operational mode, run the show path-computation-clientactive-pce detail command.
user@PCC# show path-computation-client active-pce
PCE PCE1
--------------------------------------------
General
IP address : 192.168.69.58
Priority : 0
PCE status : PCE_STATE_UP
Session type : PCE_TYPE_STATEFULACTIVE
LSP provisioning allowed : On
LSP cleanup timer : 30 [s]
PCE-mastership : main
Max unknown messages : 5
Keepalives received : 0
Keepalives sent : 0
Dead timer : 0 [s]
Elapsed as main current : 1 [s]
Elapsed as main total : 446380 [s]
Unknown msgs/min rate : 0
Session failures : 2198
Corrupted messages : 0
Delegation timeout set : 30
Delegation timeout in : 0 [s]
Delegation failures : 0
Connection down : 167092 [s]
Counters
PCReqs Total: 0 last 5min: 0 last hour: 0
PCReps Total: 0 last 5min: 0 last hour: 0
PCRpts Total: 5 last 5min: 5 last hour: 5
PCUpdates Total: 0 last 5min: 0 last hour: 0
PCCreates Total: 1 last 5min: 1 last hour: 1
Timers
Local Keepalive timer: 30 [s] Dead timer: 120 [s] LSP cleanup timer:
30 [s]
Remote Keepalive timer: 0 [s] Dead timer: 0 [s] LSP cleanup timer:
- [s]
Errors
PCErr-recv
PCErr-sent
PCE-PCC-NTFS
PCC-PCE-NTFS
Meaning The output displays information about the current active stateful PCE to which the PCC
is connected. The PCE status output field indicates the current status of the PCEP session
between a PCE and PCC.
For PCE1, the status of the PCEP session is PCE_STATE_UP, which indicates that the
PCEP session has been established with the PCC.
Copyright © 2017, Juniper Networks, Inc.730
ACX Series Universal Access Router Configuration Guide
To Next Page
Loading...
Need help?
General
