Action From operational mode, run the show path-computation-client active-pce command.
user@PCC> show path-computation-client active-pce
PCE pce1
--------------------------------------------
General
PCE IP address : 10.102.180.246
Local IP address : 10.102.180.228
Priority : 0
PCE status : PCE_STATE_UP
Session type : PCE_TYPE_STATEFULACTIVE
LSP provisioning allowed : On
P2MP LSP report allowed : On
P2MP LSP update allowed : Off
P2MP LSP init allowed : Off
PCE-mastership : main
Counters
PCReqs Total: 0 last 5min: 0 last hour: 0
PCReps Total: 0 last 5min: 0 last hour: 0
PCRpts Total: 12 last 5min: 0 last hour:
12
PCUpdates Total: 1 last 5min: 0 last hour: 1
PCCreates Total: 0 last 5min: 0 last hour: 0
Timers
Local Keepalive timer: 30 [s] Dead timer: 120 [s] LSP cleanup timer:
0 [s]
Remote Keepalive timer: 30 [s] Dead timer: 120 [s] LSP cleanup timer:
0 [s]
Errors
PCErr-recv
PCErr-sent
Type: 1 Value: 2 Count: 1
PCE-PCC-NTFS
PCC-PCE-NTFS
Meaning The output displays the active PCE that Router PCC is connected to, and the pce1 PCE
parameters and state.
Related
Documentation
• Support of the Path Computation Element Protocol for RSVP-TE Overview on page 692
751Copyright © 2017, Juniper Networks, Inc.
Chapter 23: Configuring Path Computation Element Protocol (PCEP)
To Next Page
Loading...
Need help?
General
