Juniper ACX2000 Configuration Guide

For MPLS-tagged IPv6 traffic, you specify the term’s IPv6 address-specific match
conditions under the ip-version ipv6 statement and the term’s IPv6 port-specific match
conditions under the protocol (tcp | udp) statement.
Table 68 on page 1047 describes the types of traffic for which you can configure firewall
filters.
Table 68: Firewall Filter Match Conditions by Protocol Family
Hierarchy Level at Which Match Conditions Are SpecifiedTraffic Type
[edit firewall family any filter filter-name term term-name]
For the complete list of match conditions, see Firewall Filter Match Conditions for
Protocol-Independent Traffic.
Protocol-independent
[edit firewall family inet filter filter-name term term-name]
For the complete list of match conditions, see Firewall Filter Match Conditions for IPv4 Traffic.
IPv4
[edit firewall family inet6 filter filter-name term term-name]
For the complete list of match conditions, see Firewall Filter Match Conditions for IPv6 Traffic.
IPv6
[edit firewall family mpls filter filter-name term term-name]
For the complete list of match conditions, see Firewall Filter Match Conditions for MPLS Traffic.
MPLS
[edit firewall family mpls filter filter-name term term-name ip-version ipv4 ]
For the complete list of match conditions, see Firewall Filter Match Conditions for MPLS-Tagged
IPv4 or IPv6 Traffic.
IPv4 addresses
in MPLS flows
[edit firewall family mpls filter filter-name term term-name ip-version ipv4 protocol (tcp | udp)]
For the complete list of match conditions, see Firewall Filter Match Conditions for MPLS-Tagged
IPv4 or IPv6 Traffic.
IPv4 ports in MPLS flows
[edit firewall family mpls filter filter-name term term-name ip-version ipv6 ]
For the complete list of match conditions, see Firewall Filter Match Conditions for MPLS-Tagged
IPv4 or IPv6 Traffic.
IPv6 addresses
in MPLS flows
[edit firewall family mpls filter filter-name term term-name ip-version ipv6 protocol (tcp | udp)]
For the complete list of match conditions, see Firewall Filter Match Conditions for MPLS-Tagged
IPv4 or IPv6 Traffic.
IPv6 ports in MPLS flows
[edit firewall family vpls filter filter-name term term-name]
For the complete list of match conditions, see “Firewall Filter Match Conditions for VPLS Traffic”
on page 1070.
VPLS
[edit firewall family ccc filter filter-name term term-name]
For the complete list of match conditions, see Firewall Filter Match Conditions for Layer 2 CCC Traffic.
Layer 2 CCC
1047Copyright © 2017, Juniper Networks, Inc.
Chapter 32: Configuring Firewall Filters

Juniper ACX2000 Specifications

General

Brand	Juniper
Model	ACX2000
Category	Network Router
Language	English