Juniper ACX2000 Configuration Guide

Table 77: Nonterminating Actions for Standard Firewall Filters on ACX Series
Routers (continued)
Protocol FamiliesDescriptionNonterminating Action
•
family any
•
family inet
•
family inet6
•
family mpls
•
family ccc
•
family bridge
•
family vpls
Set the packet loss priority
(PLP) level.
You cannot also configure the
three-color-policer
nonterminating action for the
same firewall filter term. These
two nonterminating actions
are mutually exclusive.
You must include the tri-color
statement at the [edit
class-of-service] hierarchy
level to commit a PLP
configuration with any of the
four levels specified. If the
tri-color statement is not
enabled, you can configure
only the high and low levels.
This applies to all protocol
families.
For information about the
tri-color statement, see
Configuring and Applying
Tricolor Marking Policers. For
information about using
behavior aggregate (BA)
classifiers to set the PLP level
of incoming packets, see
Understanding How Forwarding
Classes Assign Classes to
Output Queues.
NOTE: This action is
supported on ingress only.
loss-priority (high | medium-high | low)
•
family any
•
family inet
•
family inet6
•
family mpls
•
family ccc
•
family bridge
•
family vpls
Name of policer to use to
rate-limit traffic.
policer policer-name
Copyright © 2017, Juniper Networks, Inc.1066
ACX Series Universal Access Router Configuration Guide

Juniper ACX2000 Specifications

General

Brand	Juniper
Model	ACX2000
Category	Network Router
Language	English