Juniper ACX2000 Configuration Guide

This parameter is optional for a CCC family. If you do not configure the destination
MAC address, the default value of 0x00:0x60:0x67:0x71:0xC6:0x62 is used.
[edit services rpm rfc2544-benchmarking tests test-name test1]
user@host# set source-mac-address address
7. Specify the destination MAC address used in generated test frames.
[edit services rpm rfc2544-benchmarking tests test-name test1]
user@host# set destination-mac-address address
8. Specify the logical interface on which the RFC 2544-based benchmarking test is run.
This is a local user-to-network interface (UNI) on behalf of which the test frames are
generated when the test direction is egress.
[edit services rpm rfc2544-benchmarking tests test-name test1]
user@host# set test-interface interface-name
9. Specify the family for the benchmarking test.
[edit services rpm rfc2544-benchmarking tests test-name test1]
user@host# set family bridge
10. Specify the test mode for the packets that are sent during the benchmarking test. The
initiate-and-terminate option causes the test frames to be initiated from one end and
terminated at the same end. The initiation and termination mode requires a reflector
to be configured at the peer end to return the test frames from the peer to the
originator. The reflect option causes the test frames to be reflected on the chosen
service (IPv4, Ethernet, or bridge).
•
To configure the initiation and termination mode as the test mode on a router, use
the initiate-and-terminate option.
[edit services rpm rfc2544-benchmarking tests test-name test1]
user@host# set mode initiate-and-terminate
•
To configure the reflection mode as the test mode on a router, use the reflect option.
[edit services rpm rfc2544-benchmarking tests test-name test1]
user@host# set mode reflect
11. Specify the direction (egress | ingress) of the interface on which the test must be run.
The egress option causes the test to be run in the egress direction of the interface
(traffic sent from user-to-network interface (UNI) toward network-to-network
interface (NNI)). The ingress option causes the test to be run in the ingress direction
of the interface (traffic sent on user-to-network interface (UNI)). You cannot configure
ingress for a bridge family.
[edit services rpm rfc2544-benchmarking tests test-name test1]
user@host# set direction egress
12. Configure the outer VLAN ID for the test frames. This parameter is valid only for a CCC
or an Ethernet pseudowire family.
1349Copyright © 2017, Juniper Networks, Inc.
Chapter 37: Configuring RFC 2544-Based Benchmarking Tests

Juniper ACX2000 Specifications

General

Brand	Juniper
Model	ACX2000
Category	Network Router
Language	English