[edit services rpm rfc2544-benchmarking tests test-name test1]
user@host# set ovlan-id number
13. Configure the inner VLAN ID for the test frames. This parameter is valid only for a CCC
or an Ethernet pseudowire family.
[edit services rpm rfc2544-benchmarking tests test-name test1]
user@host# set ivlan-id number
14. Configure the priority value for the IEEE 802.1p bit in the outer VLAN tag. The priority
value is configured when the UNI interface is dual-tagged.
[edit services rpm rfc2544-benchmarking tests test-name test1]
user@host# set ovlan-priority value
15. Configure the priority value for the IEEE 802.1p bit in the inner VLAN tag. This
configuration is optional.
[edit services rpm rfc2544-benchmarking tests test-name test1]
user@host# set ivlan-priority value
16. Configure the CFI value for the outer VLAN tag. This configuration is optional.
[edit services rpm rfc2544-benchmarking tests test-name test1]
user@host# set ovlan-cfi value
17. Specify the source IPv4 address to be used in generated test frames. This parameter
is optional for both CCC and inet families. If you do not configure the
source-ipv4-address for an inet family, the source address of the interface is used to
transmit the test frames. If you do not configure the source-ipv4-address for a CCC
family, the default value of 192.168.1.10 is used.
[edit services rpm rfc2544-benchmarking tests test-name test1]
user@host# set source-ipv4-address address
18. Specify the destination IPv4 address to be used in generated test frames.
[edit services rpm rfc2544-benchmarking tests test-name test1]
user@host# set destination-ipv4-address address
19. Specify the source UDP port to be used in the UDP header for the generated frames.
If you do not specify the UDP port, the default value of 4040 is used.
[edit services rpm rfc2544-benchmarking tests test-name test1]
user@host# set source-udp-port port-number
20. Specify the destination UDP port to be used in the UDP header for the generated
frames. If you do not specify the UDP port, the default value of 4041 is used.
[edit services rpm rfc2544-benchmarking tests test-name test1]
user@host# set destination-udp-port port-number
Copyright © 2017, Juniper Networks, Inc.1350
ACX Series Universal Access Router Configuration Guide
To Next Page
Loading...
Need help?
General
