Juniper ACX2000

•
sync-interval (Slave) on page 1737
•
sync-interval (Master) on page 1738
•
synchronization (ACX Series) on page 1739
•
system-defaults on page 1740
•
tag (Routing Options) on page 1741
•
t1-options on page 1742
•
t1-options (BITS Interfaces Signal Type) on page 1743
•
temperature (Alarm Relay Output) on page 1743
•
test-finish-wait-duration (RFC 2544 Benchmarking) on page 1744
•
test-interface (RFC 2544 Benchmarking) on page 1744
•
test-iterator-duration (RFC 2544 Benchmarking) on page 1745
•
test-iterator-pass-threshold (RFC 2544 Benchmarking) on page 1745
•
test-name (RFC 2544 Benchmarking) on page 1746
•
test-profile (RFC 2544 Benchmarking) on page 1747
•
test-type (RFC 2544 Benchmarking) on page 1748
•
tests (RFC 2544 Benchmarking) on page 1749
•
timeslots on page 1750
•
timestamp-format (RFC 2544 Benchmarking) on page 1750
•
tos on page 1751
•
traceoptions on page 1752
•
traceoptions (PCE) on page 1755
•
traceoptions (Protocols PCEP) on page 1757
•
traffic-control-profiles on page 1758
•
translation-type on page 1759
•
transport ipv4 (PTP Unicast Master and Slave Interface) on page 1761
•
transport 802.3 (PTP Multicast Master and Slave) on page 1762
•
transmit-failure-threshold (RFC 2544 Benchmarking) on page 1763
•
trigger (Chassis Alarm Relay Input) on page 1763
•
ttl on page 1764
•
ttl on page 1764
•
tunnel-services (Chassis) on page 1765
•
udp-tcp-port-swap (RFC 2544 Benchmarking) on page 1766
•
unicast (Virtual Tunnel in Routing Instances) on page 1767
•
unicast-mode (Master Clock) on page 1768
•
unicast-mode (PTP Slave Interface) on page 1769
•
unicast-reverse-path on page 1770
•
update-rate-limit on page 1771
1415Copyright © 2017, Juniper Networks, Inc.
Chapter 41: Configuration Statements