Juniper ACX2000

•
reflect-mode (RFC2544 Benchmarking) on page 1697
•
rfc2544-benchmarking on page 1698
•
rib (General) on page 1699
•
rib-group (Routing Options) on page 1701
•
rpf-check (interfaces) on page 1702
•
route-distinguisher-id on page 1703
•
route-record on page 1704
•
router-id on page 1705
•
routing-options on page 1706
•
rule (Services NAT) on page 1707
•
selection-mode (Chassis Synchronization) on page 1709
•
service-set (Services) on page 1710
•
service-filter (Interfaces) on page 1712
•
service-filter (Firewall) on page 1713
•
service-package (ACX Series) on page 1714
•
service-type (RFC2544 Benchmarking) on page 1715
•
satop-options (Physical Interface) on page 1716
•
service-plane-recovery (Inline Services) on page 1717
•
short-sequence on page 1718
•
signal-type (BITS Interfaces) on page 1719
•
slave (ACX Series) on page 1720
•
source (Chassis Synchronization) on page 1721
•
source-address (Routing Options) on page 1722
•
skip-arp-iteration (RFC 2544 Benchmarking) on page 1723
•
source-ipv4-address (RFC 2544 Benchmarking) on page 1724
•
source-mac-address (RFC2544 Benchmarking) on page 1725
•
source-udp-port (RFC 2544 Benchmarking) on page 1726
•
source-routing on page 1727
•
speed (10-Gigabit Ethernet) on page 1728
•
standby on page 1729
•
static-mac on page 1730
•
stateful (ACX Series) on page 1731
•
static (Protocols Layer 2 Circuit) on page 1732
•
static (Origin Validation for BGP) on page 1733
•
step-percent (RFC 2544 Benchmarking) on page 1734
•
sustained-rate on page 1735
•
switchover-mode on page 1736
Copyright © 2017, Juniper Networks, Inc.1414
ACX Series Universal Access Router Configuration Guide