mep remote-mep-id—Numeric identifier of the peer MEP with which to perform Ethernet
synthetic frame loss measurement. The discovered MAC address of the peer MEP
is used. The range of values is from 1 through 8191.
remote-mac-address—Unicast MAC address of the peer MEP with which to perform
Ethernet synthetic frame loss measurement. Specify the MAC address as six
hexadecimal bytes in one of the following formats: nnnn.nnnn.nnnn or
nn:nn:nn:nn:nn:nn. For example, 0011.2233.4455 or 00:11:22:33:44:55. Multicast MAC
addresses are not supported.
count frame-count—(Optional) Number of frames to send to the specified peer MEP.
The range of values is from 1 through 65,535 frames. The default value is 10 frames.
local-mep mep-id—(Required when multiple MEPs are configured) Identifier for the local
maintenance endpoint.
wait interval-milliseconds—(Optional) Number of milliseconds to wait between sending
frames. You must specify this value in multiples of 100 milliseconds. The range of
values is from 100 through 50000 milliseconds. The default value is 100 milliseconds.
priority 802.1p value—(Optional) Priority of the ETH-SLM request frame supported. The
range of values is from 0 through 7. The default value is zero.
size—(Optional) Size of the data TLV to be included in the request frame. The range of
values is from 1 through 1400 bytes.
xml—(Optional) Allow the output of the command to be displayed in XML format for
ETH-SLM. Note that the only way to get output in XML format is to use the xml
argument. The display xml command does not work.
Additional Information To display the frame counts collected at a MEP as the result of this command, use the
following commands as described in the CLI Explorer:
• show oam ethernet connectivity-fault-management interfaces detail
• show oam ethernet connectivity-fault-management mep-database
• show oam ethernet connectivity-fault-management mep-statistics
To display the statistics collected at a MEP as the result of this command, use the
following commands as described in the CLI Explorer.
• show oam ethernet connectivity-fault-management synthetic-loss-measurement
• show oam ethernet connectivity-fault-management mep-statistics
To clear both the frame counts and the statistics collected for MEPs, use the clear oam
ethernet connectivity-fault-management statistics command, described in the CLI Explorer.
For a complete description of Ethernet synthetic frame loss measurement, see the ITU-T
Y.1731 Ethernet Service OAM topics in the Junos OS Network Interfaces Library for Routing
Devices.
1797Copyright © 2017, Juniper Networks, Inc.
Chapter 42: Operational Commands
To Next Page
Loading...
Need help?
General
