Required Privilege
Level
trace and maintenance
Related
Documentation
clear oam ethernet connectivity-fault-management synthetic-loss-measurement
on page 1788
•
• monitor ethernet synthetic-loss-measurement on page 1796
• show oam ethernet connectivity-fault-management loss-statistics
List of Sample Output monitor ethernet synthetic-loss-measurement on page 1799
Output Fields The monitor ethernet synthetic-loss-measurement command displays different output
at the CLI, depending on when you start a synthetic frame loss measurement:
• Table 112 on page 1798 lists the run-time output fields for the monitor ethernet
synthetic-loss-measurement command.
Output fields are listed in the approximate order in which they appear.
Table 112: monitor ethernet synthetic-loss-measurement Output Fields
Output Field DescriptionOutput Field Name
Unicast MAC address of the remote peer MEP.ETH-SLM request to
Name of the Ethernet physical, logical, or trunk interface to which the local MEP is attached.Interface
Total number of synthetic loss message (SLM) PDU frames sent from the source MEP to the
remote MEP during this ETH-SLM session.
SLM packets sent
Total number of synthetic loss reply (SLR) PDU frames received by the source MEP from the
remote MEP during this measurement session.
SLR packets received
Number of synthetic frames transmitted to the peer MEP for a test ID. A test ID is used to distinguish
each synthetic loss measurement because multiple measurements can be simultaneously activated
also on a given CoS and MEP pair. It must be unique at least within the context of any SLM for the
MEG and initiating MEP.
Local TXFC1 value
Number of synthetic frames received from the peer MEP for a test ID. The MEP generates a unique
test ID for the session, adds the source MEP ID, and initializes the local counters for the session
before SLM initiation. For each SLM PDU transmitted for the session (test ID), the local counter
TXFC1 is sent in the packet.
Local RXFC1 value
Value of the local counter TxFCl at the time of SLM frame transmission.Last Received SLR frame
TXFCf(tc)
Value of the local counter RxFCl at the time of SLR frame transmission.Last Received SLR frame
TXFCb(t
Count of frame loss associated with ingress data frames.Frame loss (near-end)
Count of frame loss associated with egress data frames.Frame loss (far-end)
Copyright © 2017, Juniper Networks, Inc.1798
ACX Series Universal Access Router Configuration Guide
To Next Page
Loading...
Need help?
General
