Juniper ACX2000

Table 114: show bgp neighbor Output Fields (continued)
Field DescriptionField Name
Internal BGP flags:
• Aggregate Label—BGP has aggregated a set of incoming labels (labels received from the peer) into
a single forwarding label.
• CleanUp—The peer session is being shut down.
• Delete—This peer has been deleted.
• Idled—This peer has been permanently idled.
• ImportEval—At the last commit operation, this peer was identified as needing to reevaluate all
received routes.
• Initializing—The peer session is initializing.
• SendRtn—Messages are being sent to the peer.
• Sync—This peer is synchronized with the rest of the peer group.
• RSync—This peer in the backup Routing Engine is synchronized with the BGP peer in the master
Routing Engine for nonstop active routing.
• TryConnect—Another attempt is being made to connect to the peer.
• Unconfigured—This peer is not configured.
• WriteFailed—An attempt to write to this peer failed.
Flags
Previous state of the BGP session:
• Active—BGP is initiating a transport protocol connection in an attempt to connect to a peer. If the
connection is successful, BGP sends an Open message.
• Connect—BGP is waiting for the transport protocol connection to be completed.
• Established—The BGP session has been established, and the peers are exchanging update messages.
• Idle—This is the first stage of a connection. BGP is waiting for a Start event.
• OpenConfirm—BGP has acknowledged receipt of an open message from the peer and is waiting
to receive a keepalive or notification message.
• OpenSent—BGP has sent an open message and is waiting to receive an open message from the
peer.
Last state
Last activity that occurred in the BGP session:
• Closed—The BGP session closed.
• ConnectRetry—The transport protocol connection failed, and BGP is trying again to connect.
• HoldTime—The session ended because the hold timer expired.
• KeepAlive—The local routing device sent a BGP keepalive message to the peer.
• Open—The local routing device sent a BGP open message to the peer.
• OpenFail—The local routing device did not receive an acknowledgment of a BGP open message
from the peer.
• RecvKeepAlive—The local routing device received a BGP keepalive message from the peer.
• RecvNotify—The local routing device received a BGP notification message from the peer.
• RecvOpen—The local routing device received a BGP open message from the peer.
• RecvUpdate—The local routing device received a BGP update message from the peer.
• Start—The peering session started.
• Stop—The peering session stopped.
• TransportError—A TCP error occurred.
Last event
Copyright © 2017, Juniper Networks, Inc.1812
ACX Series Universal Access Router Configuration Guide